Custom spacers, any size
Working out the price for Ø10 × Ø6 × 10 mm…
Made of PETG, a tough plastic that takes some heat.
Limits: Inner 2–50 mm · wall at least 1.2 mm · length 1–150 mm
What a spacer is
A spacer is a plain tube that holds two things a set distance apart, usually with a bolt or screw through the middle. The same shape is also called a standoff, a bushing or a sleeve.
This tool makes a round tube with a round hole, printed in PETG, a tough plastic that takes some heat.
How to measure
Inner size: the hole. Measure across the bolt or rod that goes through it: a 1/4 inch bolt is 1/4 in, an M6 bolt is 6 mm. If it should slide through freely, add a little, because printed holes tend to come out slightly small.
Outer size: across the outside of the tube. Match the washer or the surface it sits against, or the old spacer if you have it.
Length: the gap the spacer has to fill, end to end.
A ruler in inches works: set "Measure in" to in and type what you read, like 1/4 or 1 1/2. You see the millimeters it will be made at (we make it to the nearest 0.1 mm, which is finer than a ruler reads). Calipers, a sliding measuring tool, give the most exact numbers.
Sizes we make
Inner 2–50 mm · wall at least 1.2 mm · length 1–150 mm. The outer size must be at least the inner size + 2.4 mm, and at most 102.4 mm.
In inches: inner 1/8 to 1 15/16 in · outer at least 1/8 in bigger than the inner · length 1/16 to 5 7/8 in, and the outer size at most 4 in.
PETG, in black, white or gray.
Need a logo, a slot or an odd shape? Send a request and makers will quote.
Get a quoteQuestions
- What sizes can I order?
- Inner 2–50 mm · wall at least 1.2 mm · length 1–150 mm (in inches: inner 1/8 to 1 15/16 in · outer at least 1/8 in bigger than the inner · length 1/16 to 5 7/8 in, and the outer size at most 4 in). The outer size must be at least the inner size + 2.4 mm. Sizes are kept to 0.1 mm.
- Can I type inches?
- Yes. Set "Measure in" to in and type decimals or fractions, like 0.25, 1/4 or 1 1/2. The page shows the millimeters each size will be made at, and your spacer is printed at exactly those millimeters.
- What is it made of?
- PETG, in black, white or gray.
- Who makes it?
- We print your spacers from a file made to your sizes, then ship them to you.
- How much is shipping?
- The same as everything else in the shop. The page shows it under the price for the number of spacers you choose. Free shipping on orders over $15.
- Why is there no price for my size?
- The price is worked out from the print for exactly your sizes. When that cannot be done automatically, we show no number. Send the sizes as a request instead and makers will quote; your sizes come with it.
- Can I share a size with someone?
- Yes. The page address keeps the sizes you typed, so copy it and send it.
- Can it have a slot, a flat side or a logo?
- Not with this tool: it makes a plain round tube. For anything else, send a request with a photo or a sketch and makers will quote.